Posted by Wally/FloorUSA on December 08, 19102 at 17:52:06:
In Reply to: 1/2 engineered wood floor problems posted by hdayanan on December 08, 19102 at 16:11:19:
: I am trying to install 1/2" Mannington engineered floor square edges with a bostitch flooring stapler. The problem is at a particular angle, at the point where the staples were driven and right behind it, I see a small bump or swelling at the local area. I tried increasing the pressure but results in cracking of the tongue. appreciate any suggestions.
: Thankyou
: Dan
:
:
:
Hi Dan,
Do you have the 1/2" plate for the Bostich? We nomally use a smaller Senco for engineered. The Bostitch has a large crown for engineered products. You may want to check your installation guide.
Wally