 DMX Switchpack - This DMX-controlled switching device allows you to turn on and off up to six 350 watt devices with the Martin 2518 DMX controller or any other DMX board. |
| |
 Flight Cases/Touring Kits - Tough enough for the hardest tour... All flight cases are constructed of 9 mm (3/8") pressure-treated plywood. The exterior is covered with a tough- grained finish, aluminium edge protection, and tough steel corners. The wheels are the well-known GUITEL blue rubber type. |
| |
 Lamps - Martin Professional supplies Gas discharge type lamps up to 85 watts and Halogen type lamps up to 300 watts. |
| |
 MPBB1 Uploader - The MPBB1 is a "multi-purpose black box" that works together with the Martin Software Up loader program to allow you to update software and adjust settings on selected Martin fixtures remotely via the serial link. |
| |
 MP2 software Uploader - The MP2 is a fixture software uploader and maintenance device that works together with the Martin software uploader program v.4.0 (windows 95/98 PC required). It allows you to update software and adjust settings on selected Martin fixtures remotely via the serial link. |
| |
 RS-485 Optosplitter - This optically isolated splitter amplifier allows you to add 4 branches to the data link for safe and trouble-free operation of larger DMX installations. |
| |
 Cables - All Martin link cables are 24 AWG shielded twisted pair cables. The 24 AWG can be used for runs up to 300 meters. For longer runs, or when more than 32 fixtures are connected to the link, the Martin optosplitter is recommended. Link termination is achieved by inserting a 120 ohm resistor across the signal + (hot) and signal - (cold) wires; it is important for trouble-free communication. If a splitter is used, terminate each branch of the link. The easiest way to terminate the link is to insert a male termination plug into the data output cable of the last fixture. A termination plug is simply an XLR connector with a 120 ohm resistor soldered across pins 2 and 3. |
| |
 516-II Converter - The 516-II converter is a handy tool which converts DMX to 0-10 V analogue output. It can be used to control analogue dimmers or anything that requires a standard 0-10 V control voltage. |
| |
 Clamps - Clamps are fasten to the existing or new 1/4-turn Omega brackets, include a grade 8.8 M12 self-locking nut and bolt for maximum security and are manufactured from premium extruded aluminum. |
| |
 DMX Interface - The DMX Interface allows you to control those discontinued Martin products that are not compatible with DMX-512. The DMX Interface works with any DMX controller such as the LightJockey or ProScenium. |
| |
Martin Professional supplies hundreds of customized varieties and fuctions to complement any commercial or residential application.
For additional information click here and fill-out our web-based support form or call us at (800) 559-4339 for details.
